Canon imagePRESS C1 Service Manual - page 992
Chapter 16
16-95
8. HV-PRI
T-16-95
9. HV-TR
LD-OFS-Y/M/C/K
Adjust the color balance of low-density area. (Y/M/C/K color)
2
Adjustment range
-8 to +8
[Factory setting value / Value after RAM clear: 0]
Use of this mode must be avoided as much as possible when the machine has been operating
normally.
MD-OFS-Y/M/C/K
Adjust the color balance of middle-density area. (Y/M/C/K color)
2
Adjustment range
-8 to +8
[Factory setting value / Value after RAM clear: 0]
Use of this mode must be avoided as much as possible when the machine has been operating
normally.
HD-OFS-Y/M/C/K
Adjust the color balance of high-density area. (Y/M/C/K color)
2
Adjustment range
-8 to +8
[Factory setting value / Value after RAM clear: 0]
Use of this mode must be avoided as much as possible when the machine has been operating
normally.
COPIER>ADJUST>HV-PRI
Subheading Contents
Level
PRIMARY
Adjust the current of the primary charging assembly.
1
Adjustment range: 0 to 1200 (Unit: µA)
[Factory setting value / Value after RAM clear: 1000]
GRID
Adjust the grid bias of the primary charging assembly.
1
Setting range: 0 to 1000 (Unit: 1V)
[Factory setting value / Value after RAM clear: 464]
HVRATE-3
Adjust the parameter setting ratio of the primary charging bias / laser power. (Feeding speed: 1/3
speed)
Adjustment method
Adjust the parameter setting ratio of the primary charging bias / laser power at the feeding speed
of 1/3 speed.
2
Setting range: 0 to 100 (This can be set in the unit of 1.)
[Factory setting value / Value after RAM clear: 100]
COPIER>ADJUST>COLOR
Subheading Contents
Level