Canon imagePRESS C1 Service Manual - page 1037
Chapter 16
16-140
MN-CON
RAM clear for the SRAM board of the main controller PCB
Operation method
1) Select this item and press the OK key.
2) Turn OFF/ON the main power.
- The RAM data is cleared after the main power switch is turned OFF/ON.
- When this mode is executed, all the data in the SRAM board is initialized.
The file control information for a hard disk is also initialized, and image data in the hard disk
cannot be read. Before you execute this mode, be sure to inform a user that all images in the box
are going to be initialized and receive prior approval from him/her.
1) Print out the service mode data by COPIER > FUNCTION > MISC-P > P-PRINT.
2) Select this item and press the OK key. The machine is automatically activated and displays a
message indicating "please turn on the main power again".
3) Turn OFF/ON the main power.
1
CARD
Clear the data related to the card ID (section).
The data related to the card ID is cleared after the main power switch is turned OFF/ON.
Operation method
1) Select this item and press the OK key.
2) Turn OFF/ON the main power.
1
W-TN-CLR
Clear the warning and error indicating waste toner box full.
After replacing the waste toner box, clear the warning/error and the counter detecting waste toner
box full.
Method of Operation
Select the item to highlight, and press the OK key to start operation.
1
LANG-ERR
Clear the language-related error.
When a language-related error has occurred after switching a default language to a different one,
use this mode to eliminate the error and set the language to a default language.
1
ERDS-DAT
Clear the SRAM data of E-RDS.
Set the SCM value stored in the SRAM of E-RDS back to the factory setting value.
The SRAM data is cleared after the OK key is pressed.
Operation method
1) Select this item and press the OK key.
2) When the data is cleared normally, OK is displayed.
Reference:
- Always use this mode to execute the bootable version-up in the environment where E-RDS is
used. The usage of SRAM in E-RDS differs depending on the version. Data mismatch occurs if
SRAM data is not cleared.
- The items related to E-RDS stored in the SRAM are ON/OFF of E-RDS, port number of a server,
SOAP URL of a server, and schedule of communication with a server (how often is the data
obtained?), etc.
The following setting values are cleared.
- COPIER > FUNCTION > INSTALL > E-RDS
- COPIER > FUNCTION > INSTALL > RGW-PORT
- COPIER > FUNCTION > INSTALL > RGW-ADR
- COPIER > FUNCTION > INSTALL > COM-LOG
1
SND-STUP
Perform initialization of the transmission reading setting. (Execute this mode when switching a
language setting.)
2
COPIER>FUNCTION>CLEAR
Subheading Contents
Level