Canon imagePRESS C1 Service Manual - page 976
Chapter 16
16-79
T-16-77
COPIER>ADJUST>BLANK
Subheading Contents
Level
BLANK-T
Enter an adjustment value for non-image width (lead edge).
Adjustment method
- When you executed 'RAM clear' for the main controller PCB or replaced the SRAM PCB, enter
the value indicated in the service label.
1
Adjustment range: 0 to 1000
[Factory setting value: Factory adjustment value / Value after RAM clear: 94]
BLANK-L
Enter an adjustment value for non-image width (left edge).
Adjustment method
- When you executed 'RAM clear' for the main controller PCB or replaced the SRAM PCB, enter
the value indicated in the service label.
1
Adjustment range: 0 to 1000
[Factory setting value: Factory adjustment value / Value after RAM clear: 59]
BLANK-R
Enter an adjustment value for non-image width (right edge).
Adjustment method
- When you executed 'RAM clear' for the main controller PCB or replaced the SRAM PCB, enter
the value indicated in the service label.
1
Adjustment range: 0 to 1000
[Factory setting value: Factory adjustment value / Value after RAM clear: 59]
BLANK-B
Enter an adjustment value for non-image width (trail edge).
Adjustment method
- When you executed 'RAM clear' for the main controller PCB or replaced the SRAM PCB, enter
the value indicated in the service label.
1
Adjustment range: 0 to 1000
[Factory setting value: Factory adjustment value / Value after RAM clear: 47]
BLANK-C1
Set a lead edge margin for Cassette 1.
Adjustment method
- When you executed 'RAM clear' for the main controller PCB or replaced the SRAM PCB, enter
the value indicated in the service label.
1
Adjustment range: -35 to +35
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
BLANK-C2
Set a lead edge margin for Cassette 2.
Adjustment method
- When you executed 'RAM clear' for the main controller PCB or replaced the SRAM PCB, enter
the value indicated in the service label.
1
Adjustment range: -35 to +35
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
BLANK-C3
Set a lead edge margin for Cassette 3.
Adjustment method
- When you executed 'RAM clear' for the main controller PCB or replaced the SRAM PCB, enter
the value indicated in the service label.
1
Adjustment range: -35 to +35
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]