Canon imagePRESS C1 Service Manual - page 589
Chapter 9
9-52
F-9-135
3) Remove the external heat sub thermistor [1].
- 1 screw [2]
- 1 mount [3]
F-9-136
9.7.18 Inlet Thermistor
9.7.18.1 Preparation for Removing the Inlet Main
Thermistor/Sub Thermistor
0014-0182
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front door.
2) Pull out the fixing/feeding unit toward you.
3) Remove the fixing belt unit. (page 9-38)Reference [Removing the Fix-
ing Belt Unit]
4) Remove the fixing belt. (page 9-42)Reference [Removing the Fixing
Belt]
9.7.18.2 Removing the Inlet Main Thermistor/Sub
Thermistor
0014-0183
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the heater contact cover [1].
- 2 screws (black) [2]
- 1 mount [3]
- 1 screw [4]
- 1 screw (silver) [5]
F-9-137
2) Remove the inlet main thermistor [1] and the sub thermistor [2].
- 2 screws [3]
F-9-138
Be sure not to damage or break the steering roller overlapped with the inlet
thermistor / inlet sub-thermister when isolating it.
Points to Note When Mounting the Inlet Main Thermistor/Sub
Thermistor
Make sure not to pinch harnesses to the areas [A] and [B] shown in the figure
below.
F-9-139
9.7.19 Fixing Thermal Switch
9.7.19.1 Preparation for Removing the Fixing Thermal
Switch
0014-0206
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front door.
2) Pull out the fixing/feeding unit toward you.
9.7.19.2 Removing the Fixing Thermal Switch
0014-0207
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Detach the fixing upper cover [1].
- 2 stepped screws [2]
- 1 screw [3]
[1]
[3]
[2]
[1]
[2]
[3]
[2]
[3]
[4]
[5]
[1]
[1]
[2]
[3]
[A]
[B]
[A]
[B]