Canon imagePRESS C1 Service Manual - page 779
Chapter 14
14-44
F-14-55
3. Cut the tie-wrap [2] binding the fixing heater cable.
Note: When cutting the tie-wrap, cut only the head of the tie-wrap with a nipper while paying attention not to damage the cable.
4. After cutting the tie-wrap [2], pull the cable toward the metal plate (in the direction of the arrow) [5] by approx. 10mm, and then sleave the part [6] of the
cable to release stress. After sleaving, check to make sure that the cable does not escape from the saddle edge [3].
F-14-56
5. Push the connector pin from the backside of the fixing drawer connector by the finger, and then check to see from the front side of the connector if the
connector pin [7] is still set back far from the connector frame edge. Or replace the fixing heater cable unit by a new one.
Reference: The fixing heater cable unit that is offered as a service part does not have the tie-wrap [2].
F-14-57
6. Mount the fixing heater cable unit to the fixing assembly with the 3 screws [4].
Note: After mounting the unit, be sure to make sure that the cable is not out of the guide [8].