Canon imagePRESS C1 Service Manual - page 874
Chapter 15
15-11
E540
There is an error in up and down movement of the upper tray (finisher/saddle finisher).
8001 There is a clock error in up/down motor of the upper tray.
1)Check the No. 1 tray area sensors 1 through 3. Are the sensors
normal?
2)Check the wiring between the finisher controller PCB and the
No. 1 tray shift motor. Is the wiring normal?
3)Is there a fault in the up/down mechanism of the tray/
4)Try replacing the No. 1 shift motor. Is the problem corrected?
8002 Area error
1) Check the No. 1 tray area sensors 1 through 3. Are the sensors
normal?
2)Check the wiring between the finisher controller PCB and the
No. 1 tray shift motor. Is the wiring normal?
3)Is there a fault in the up/down mechanism of the tray/
4)Try replacing the No. 1 shift motor. Is the problem corrected?
8003 Safety switch activation
1) Check the No. 1 tray area sensors 1 through 3. Are the sensors
normal?
2)Check the wiring between the finisher controller PCB and the
No. 1 tray shift motor. Is the wiring normal?
3)Is there a fault in the up/down mechanism of the tray/
4)Try replacing the No. 1 shift motor. Is the problem corrected?
0004 In the case of detecting fault in clock
1) Check the No. 1 tray area sensors 1 through 3. Are the sensors
normal?
2)Check the wiring between the finisher controller PCB and the
No. 1 tray shift motor. Is the wiring normal?
3)Is there a fault in the up/down mechanism of the tray/
4)Try replacing the No. 1 shift motor. Is the problem corrected?
0005 In the case of detecting fault in speed
1) Check the No. 1 tray area sensors 1 through 3. Are the sensors
normal?
2)Check the wiring between the finisher controller PCB and the
No. 1 tray shift motor. Is the wiring normal?
3)Is there a fault in the up/down mechanism of the tray/
4)Try replacing the No. 1 shift motor. Is the problem corrected?
0006 In the case of detecting fault in accelerating time
1) Check the No. 1 tray area sensors 1 through 3. Are the sensors
normal?
2)Check the wiring between the finisher controller PCB and the
No. 1 tray shift motor. Is the wiring normal?
3)Is there a fault in the up/down mechanism of the tray/
4)Try replacing the No. 1 shift motor. Is the problem corrected?
0007 In the case of detecting Lock Detect signal
1) Check the No. 1 tray area sensors 1 through 3. Are the sensors
normal?
2)Check the wiring between the finisher controller PCB and the
No. 1 tray shift motor. Is the wiring normal?
3)Is there a fault in the up/down mechanism of the tray/
4)Try replacing the No. 1 shift motor. Is the problem corrected?
Code
Cause (Detection Description)
Remedy