Canon imagePRESS C1 Service Manual - page 181
Chapter 2
2-87
tion of the arrow.
- 4 screws (TP; M4X6) [4]
24) Fix the reader [1].
- 2 Stepped screws (RS; tighten; 6.4X2.5) [5]
F-2-326
25) Attach the reader rear right cover [1]
- 2 screws (TP; M4X6) [2]
F-2-327
26) Connect the one side of the reader communication cable [1] with the I/F
connector.
F-2-328
27) Connect the reader power supply cable [1].
F-2-329
28) While inserting the film [1] into the copy board glass, attach the reader
front cover [2].
- 2 magnetic catches [3]
- 2 Flat head screw (M4X8) [4]
F-2-330
29) Attach the reader upper right cover [1].
- 2 screws (RS tighten; M4X8) [2]
Before attaching the reader fixing plate R (rear right), be sure to attach the
parts of the DADF-R1 described below. (Reader installation procedure
step5 to 20)
MEMO:
1. In the case of installing the DADF-R1, be sure to attach the following
parts of the DADF-R1 before attaching the reader fixing plate R (rear right)
in order to improve operational efficiency.
- Fan unit
- Fan holder
- Fan duct
- Electrostatic filter
2. After attaching the reader fixing plate R (rear right), continue the
procedure from step 24 described below.
[2]
[1]
[3]
[4]
[4]
[5]
[1]
[2]
MEMO:
Make sure to place the reader power supply cable as shown in the diagram.
(Because it may cause the difficulty when attaching the upper rear face
cover 3 as the following order.)
[1]
[1]
[1]
[2]
[3]
[4]
[3]
[4]