Canon imagePRESS C1 Service Manual - page 199
Manual is about: imagePRESS C1 Series
of
1265
Chapter 2
2-105
2. Connecting to the host machine.
1) Remove screw [2] to remove the blind plate [1] from the power core mount of the papar deck.
F-2-401
2) Install the supplied AC input connector [1] in two steps ([A] > [B]).
F-2-402
3) Using two binding screws (M4X4) [1], install the relay hareness unit [2] to the rear side panel [3] of the paper deck.
4) Insert the bind locks of the cable ties in the holes (at [A] shown below) in the rear side panel to secure the relay harness.
5) Connect the connector at both ends of the relay harness unit to the heater connector [4] and AC power connector [5] respectively.
[2]
[1]
[1]
[A]
[B]