Canon imagePRESS C1 Service Manual - page 868
Chapter 15
15-5
E012
There is an error in the drum ITB motor
0001 After motor start-up, a lock state is not identified for 1 sec or more. Check the photosensitive drum, the ITB area and drum/ITB motor;
and then, turn off and then on the main power.
E013
There is clogging by waste toner
0001 Full level error of waste toner
After detecting full level of waste toner, software counter reaches
10,000.
Check the amount of waste toner; then, turn off and then on the
main power.
If you have replaced the waste toner, reset the reading in the
following (in service mode): COPIER/FUNCTION/CLEAR/
W_TN_CLR
0002 The waste toner full level sensor activates for 200ms.
After cleaning the waste toner pipe, execute the followings in
service mode: COPIER > FUNCTION > CLEAR > W-TN-CLR
0005 Error in secondary transfer waste toner full level. Reaching of
60,000 prints
After cleaning the waste toner retainer of secondary transfer unit,
reset in service mode by selecting the followings: COPIER >
COUNTER > MISC > 2TC-BOX
0006 Error in offset adjustment of waste toner full-level sensor
After disposing the waste toner, reset the reading of the waste
toner counter value by executing the followings in service mode:
COPIER > COUNTER > MISC > WST-TNR
E014
Error in fixing motor
0002 After stabilized rotation of the motor, a lock state is not identified
for 1 sec or more.
Check the fixing motor (fixing feed assembly); then, turn off and
then on the main power.
Error in belt drive motor
0003 Detects unlock of motor lock for 1 sec or more after the belt drive
motor performs stabilized rotation.
Check the connector of the belt drive motor, or replace the motor.
E015
There is an error in detecting decurler home position
0001 Error that the decurler entering level HP1 sensor cannot detect
within two seconds
After checking the connection of decurler, turn off and then on the
main power
0002 Error that the decurler entering level HP2 sensor cannot detect
within two seconds
After checking the connection of decurler, turn off and then on the
main power
Code
Cause (Detection Description)
Remedy