Canon imagePRESS C1 Service Manual - page 635
Chapter 10
10-33
F-10-137
10.5.16 AC Driver PCB
10.5.16.1 Preparation for Removing the AC Driver PCB
0013-9288
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the rear lower cover. (page 10-14)Reference [Removing the
Rear Lower Cover]
10.5.16.2 Removing the AC Driver PCB
0013-9292
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the connector [1] and 5 faston terminals [5], and remove the cable
[2].
- 3 edge saddles [3]
- 1 clamp [4]
F-10-138
2) Remove 9 connectors [1].
F-10-139
3) Pull out the AC driver PCB [1].
- 5 screws [2]
F-10-140
4) Remove the 2 connectors [1], and remove the AC driver PCB [2].
F-10-141
10.5.17 Pickup Driver PCB
10.5.17.1 Preparation for Removing the Pick-Up Driver
PCB
0013-9393
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the rear upper cover. (page 10-14)Reference [Removing the
Rear Upper Cover]
2) Remove the rear lower cover. (page 10-14)Reference [Removing the
Rear Lower Cover]
3) Remove the DC power supply assembly. (page 10-22)Reference [Re-
moving the Power Supply Assembly]
10.5.17.2 Removing the Pick-Up Driver PCB
0013-9394
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the pick-up driver PCB [1].
- 7 clamps [2]
- 5 screws [3]
- 1 PCB support [4]
[1]
[2]
[2]
[2]
[2]
[3]
[3]
[3]
[3]
[3]
[1]
[2]
[3]
[4]
[5]
[1]
[1]
[1]
[2]
[2]
[1]
[2]