Canon imagePRESS C1 Service Manual - page 990
Chapter 16
16-93
5. V-CONT
T-16-92
BLANK-C1
Set a lead edge margin for Cassette 1.
Adjustment method
- When you executed 'RAM clear' for the main controller PCB or replaced the SRAM PCB, enter
the value indicated in the service label.
1
Adjustment range: -35 to +35
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
BLANK-C2
Set a lead edge margin for Cassette 2.
Adjustment method
- When you executed 'RAM clear' for the main controller PCB or replaced the SRAM PCB, enter
the value indicated in the service label.
1
Adjustment range: -35 to +35
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
BLANK-C3
Set a lead edge margin for Cassette 3.
Adjustment method
- When you executed 'RAM clear' for the main controller PCB or replaced the SRAM PCB, enter
the value indicated in the service label.
1
Adjustment range: -35 to +35
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
BLANK-C4
Set a lead edge margin for Cassette 4.
Adjustment method
- When you executed 'RAM clear' for the main controller PCB or replaced the SRAM PCB, enter
the value indicated in the service label.
1
Adjustment range: -35 to +35
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
BLANK-PD
Set a lead edge margin for the side paper deck
Adjustment method
- When you executed 'RAM clear' for the main controller PCB or replaced the SRAM PCB, enter
the value indicated in the service label.
1
Adjustment range: -35 to +35
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
COPIER>ADJUST>V-CONT
Subheading Contents
Level
EPOTOEST
Electric potential offset value
1
Adjustment range: -100 to 100 (Unit: 1V)
[Factory setting value / Value after RAM clear: 0]
COPIER>ADJUST>BLANK
Subheading Contents
Level