Canon imagePRESS C1 Service Manual - page 1060
Chapter 16
16-163
DM-SW
Switching-over of the enabling / disabling of the image density correction control or image
gradation correction control.
2
Not used in this machine
Setting range
0: No implemented
1: Always implemented
2: Always implemented
3: Always implemented
4: Always implemented
Change the interval (Default: 200 copies) using COPIER/OPTION/BODY/(INTROT-1/
INTROT-2/INTROT-T).
Standard value
3
The setting value becomes valid after the main power switch is turned OFF / ON.
RAW-DATA
Make a setting to print out the received data as it is.
When there is a problem in the received image, this mode is used to determine whether the
problem is caused by the data contents or image processing.
2
Setting range
0: Normal operation
1: Print out the received data as it is.
Standard value
0
FDW-DLV
Select the 'face up' or 'face down' delivery when specifying multiple copies.
When multiple copies are specified, 'face up' delivery is usually performed. However, this mode
is provided to perform 'face down' delivery to guarantee stacking condition.
(However, this mode is invalid when a finisher is installed.)
2
Setting range
0: 'Face up' for all setting for one sheet of document
1: 'Face up' when specifying one copy, and 'face down' when specifying multiple copies for one
sheet of document
Standard value
0
The setting mode becomes valid after the power switch is turned OFF/ON.
RMT-LANG
Switch the remote UI language used on Web.
Setting method
Select the language code using the +/- key.
2
IFAX-LIM
Restrict the number of lines output when receiving large volume of data by iFAX
2
Setting range
0: No restriction
0 to 999
Standard value
500
SMTPTXPN
Change the port number for SMTP transmission.
2
Setting range
0 to 65535 (incremented by 1)
Standard value
25
SMTPRXPN
Change the port number of SMTP reception.
2
Setting range
0 to 65535 (incremented by 1)
Standard value
25
POP3PN
Change the port number of POP reception.
2
Setting range
0 to 65535 (incremented by 1)
Standard value
110
COPIER>OPTION>BODY
Subheading Contents
Level