Canon imagePRESS C1 Service Manual - page 1161
Chapter 16
16-264
ACR-LV-L
Setting of the timing of ACR (Auto Carrier Refresh) in single clear mode
2
Setting range: -4 to +2
Standard value: 0
CL4CMDL
Setting for switching of "clear model / 4-color model"
The condition where L toner is absent is not considered as an error, and operation is performed as
a 4-color toner model.
1
Setting range: 0, 1
0: Clear toner is present (5C model)
1: Clear toner is absent (4C model, degenerate mode)
CLCONFIG
Switching of 5-color/4-color configuration
Change the 5-color/4-color configuration of the engine.
0: 5-color mode, 1: 4-color mode
* Data is retained in both MN-CON and DCON.
1
Setting range: 0-1
Factory setting value: 0
L-MX-SET
Adjustment of the L toner deposit (Supporting 100% deposit)
When this item is set to ON, 100% deposit is specified.
1
Setting range: OFF/ON
Factory setting value: OFF
MAG-V-1
Correction of the main scanning magnification for 2nd side printing (64 to 105g)
Enable correction of the main scanning magnification for 2nd side printing of large paper (1-sheet
paper).
2
Setting range: -50 to 50
Factory setting vaue: 0
Amount of the change for 1 increment: 0.01%
MAG-H-1
Correction of the sub scanning magnification for 2nd side printing (64 to 105g)
Enable correction of the sub scanning magnification for 2nd side printing of large paper (1-sheet
paper).
2
Setting range: -50 to 50
Factory setting vaue: 0
Amount of the change for 1 increment: 0.01%
MAG-M-1
Specifying a material for correction of magnification for 2nd side printing (64 to 105g)
Specify a material for correction of magnification for 2nd side printing of large paper (1-sheet
paper)
0: No setting
1: High quality paper
2: Single-sided coated paper
3: Double-sided coated paper
4: Recycled paper
5: Emboss paper
6: Film
7: Label
8: Postcard
9: Vellum
10: Cotton
2
Setting range: 0 to 10
Factory setting value: 0
MAG-V-2
Correction of the main scanning magnification for 2nd side printing (106 to 150g)
Enable correction of the main scanning magnification for 2nd side printing of large paper (1-sheet
paper).
2
Setting range: -50 to 50 (Factory setting value: 0)
The value is incremented by 0.01%
MAG-H-2
Correction of the sub scanning magnification for 2nd side printing (106 to 150g)
Enable correction of the sub scanning magnification for 2nd side printing of large paper (1-sheet
paper).
The value is incremented by 0.01%.
2
Setting range: -50 to 50
(Factory setting value: 0
The value is incremented by 0.01%.
MAG-M-2
Specifying a material for correction of magnification for 2nd side printing (106 to 150g)
Specify a material for correction of magnification for 2nd side printing of large paper (1-sheet
paper)
0: No setting
1: High quality paper
2: Single-sided coated paper
3: Double-sided coated paper
4: Recycled paper
5: Emboss paper
6: Film
7: Label
8: Postcard
9: Vellum
10: Cotton
2
Setting range: 0 to 10
Factory setting value: 0
COPIER > OPTION > BODY
Subheading Contents
Level