Canon imagePRESS C1 Service Manual - page 684
Chapter 11
11-39
3) When login service application you have selected turns to Start after Restart, turn off the device's main power, and turn it back on after 10 seconds.
F-11-57
11.1.24 Initializing the Password
0018-6636
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+
1) Get the switch license for initializing the password.
Request the support of the regional headquarters of the Canon for switch license for initializing the password presenting the device serial number.
2) Click [Login] button leaving Password field blank or entering incorrect password. The Return to install Password Settings area appears. Click [Browse..] button
and select the switch license file prepared in advance.
F-11-58
3) When you click [Initialize] button, the confirmation message appears. Click [OK] button. Then Login page opens. Enter the default password 'MeapSmsLogin'
to log in. The password is case-sensitive.
If you click [Cancel] button, the Login page opens without initializing the password.
11.1.25 Creating a Backup for MEAP Application Area, Formatting the Hard Disk, Restoring the MEAP Application Area with
the Backup, Using the SST (Service Support Tool)
0018-6637
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+
With previous devices, the area of HDD where MEAP application resides can be backed up to PC when formatting HDD.
However, HDD format with SST cannot be performed with this device due to specification reasons. Backup operation of MEAP application area with SST can be
done but cannot be used for the foregoing purpose.
If restoring the backup data without formatting HDD, the data such as setting information may not be consistent. Thus, do not backup the MEAP application area.