Canon imagePRESS C1 Service Manual - page 905
Chapter 16
16-8
3.ANALOG
T-16-3
4.CST-STS
T-16-4
PDL-FNC1
Display the available PDL. (1)
b31: BDL b30: PS b29: PCL b28: PDL b27: LIPS b26: N201 b25: I5577 b24: ESC/P b23:
HPGL b22: HPGL2 b21: IMAGING b20: KS b19 - 16: Reserve (This is going to be used when
a PDL is newly added.)
1
PDL-FNC2
Display the available PDL. (2)
b15 - 0: Reserve (This is going to be used when a PDL is newly added.)
1
HDD
Display the model name of the HDD.
30 characters or less
1
PCI1
Display the name of the board connected to PCII.
30 characters or less
"-" (hyphen) is displayed when the board is not connected.
- Voice board:
- Encryption board:
- GIGA Ethernet board:
1
USBH-SPD
Display the connection speed of the USB device.
Display the connection speed of the eight USB devices connected to the USB-Host chip.
- OFF
- LOW
- FLL
- HGH
2
COPIER>DISPLAY>ANALOG
Subheading
Contents
Level
TEMP
Use it to check the machine inside temperature (environment sensor; in deg C).
1
HUM
Use it to check the machine inside humidity (environment sensor; in %RH).
1
ABS-HUM
Use it to check moisture content (environment sensor; in g).
1
DR-TEMP
Temperature around the photosensitive drum
Display the drum surface temperature detected by the drum thermistor.
Unit: deg C
Setting range: 0 to 60 deg C
1
FIX-UC
Use it to check the surface temperature of the middle of the fixing upper roller (as detected by the
main thermistor; in deg C)
1
FIX-UE
Use it to check the surface temperature at the edge of the fixing upper roller (as detected by the
sub thermistor; in deg C)
1
FIX-LC
Use it to indicate the temperature of the center of the fixing lower roller. unit: deg C
1
FIX-LE
Use it to indicate the temperature of the edge of the fixing lower roller. unit: deg C
1
FIX-EXC
Use it to indicate the temperature of the center of the outside heating roller. unit: deg C
1
FIX-EXE
Use it to indicate the temperature of the edge of the outside heating roller unit: deg C
1
DR-TEMPL
Temperature of the drum thermopile
Display the drum surface temperature detected by the thermopile.
Unit: deg C
Setting range: 0 to 60 deg C
1
COPIER>DISPLAY>CST-STS
Subheading
Contents
Level
WIDTH-MF
Use it to check the width of paper in the manual feed tray (in mm).
2
COPIER>DISPLAY>ACC-STS
Subheading
Contents
Level