Canon imagePRESS C1 Service Manual - page 587
Chapter 9
9-50
F-9-123
2) Remove the pressure pad cover [1].
- 5 screws [2]
F-9-124
9.7.13.3 After Replacing the Pressure Pad Cover
0014-6123
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
Before installing a belt, apply silicon oil (S-20; FY9-6011) to the marked
area of the pressure pad cover (within the radius of about 200 mm from the
center).
Apply silicon oil to the pressure pad cover, after soaking lint-free paper into
the oil to the extent that the oil does not drip from the paper.
F-9-125
[1] pressure pad cover
9.7.14 Fixing Main Thermistor
9.7.14.1 Preparation for Removing the Fixing Main
Thermistor
0014-0208
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front door.
2) Pull out the fixing/feeding unit toward you.
9.7.14.2 Removing the Fixing Main Thermistor
0014-0209
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Detach the fixing upper cover [1].
- 2 stepped screws [2]
- 1 screw [3]
F-9-126
2) Remove the fixing main thermistor unit [1].
- 1 connector [2]
- 1 screw [3]
F-9-127
3) Remove the fixing main thermistor [1].
- 1 screw [2]
- 1 mount [3]
F-9-128
9.7.15 Fixing Sub Thermistor
9.7.15.1 Preparation for Removing the Fixing Sub
Thermistor
0014-0210
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front door.
2) Pull out the fixing/feeding unit toward you.
9.7.15.2 Removing the Fixing Sub Thermistor
0014-0211
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the fixing upper cover [1].
- 2 stepped screws [2]
- 1 screw [3]
[2]
[2]
[3] [4]
[5]
[5]
[7]
[1]
[6]
[1]
[2]
[1]
[1]
[2]
[3]
[3]
[1]
[2]
[1]
[2]
[3]