Canon imagePRESS C1 Service Manual - page 747
Chapter 14
14-12
F-14-15
5. Clean the shafts [C] through [H] with lint-free paper impregnated with alcohol.
Note: When cleaning, take care not to get injury from the sharp edge of the stays or legs of screws.
F-14-16
6. Wipe the brand-new fixing roller, collecting roller, and heating roller with lint-free paper that comes with the fixing roller in order to prevent dust from
being left on the rollers.
7. Mount the brand-new fixing roller, collecting roller, and heating roller, and the fixing belt assembly onto this machine.
Note: When securing the fixing upper unit after mounting all the rollers above, be sure to insert the pin on the fixing plate into the shaft hole, and then tighten
the screw to secure the fixing plate. If the screw is tightened incompletely, the jam code "010E", the error code "E007" or abnormal noise may occur.
FL2-6945 Fixing Roller
FC7-0169 Roller
FC7-0932 Heating Roller
14.3.1.4.4 Lines (smeared image): Mylar comes off post duct in P-kit assembly
0019-5457
imagePRESS C1 P / imagePRESS C1 / Color Image Reader-H1 / imagePRESS C1 (CUSTOM) / imagePRESS C1+ (Printer) / imagePRESS C1+
[ Inspected by Canon Inc. ]
Description
Since the end portion(s) (rear/front) of the mylar came off [A] the post duct in the P-kit assembly, lines (smeared image) [C] occurred in the main scanning
direction (the paper-feeding direction [B]).