Canon imagePRESS C1 Service Manual - page 979
Chapter 16
16-82
9. COLOR
T-16-80
OFSTP3C
Adjust the density at test print reading
Keep the C density adjustment value when test print reading was performed (Media 3)
1
Adjustment range: -128 to +128
Standard value: 0
When replacing the reader controller, input the value written on the service label once again.
OFSTP3K
Adjust the density at test print reading
Keep the K density adjustment value when test print reading was performed (Media 3)
1
Adjustment range: -128 to +128
Standard value: 0
When replacing the reader controller, input the value written on the service label once again.
OFSTP3LM
Not used
1
OFSTP3LC
Not used
1
COPIER>ADJUST>COLOR
Subheading Contents
Level
ADJ-Y/M/C/K
Adjust the color balance for users. (Y/M/C/K color)
Adjustment method
- When you set a larger value, the image density becomes darker.
- When you set a smaller value, the image density becomes lighter.
1
Adjustment range
-8 to +8
[Factory setting value / Value after RAM clear: 0]
OFST-Y/M/C/K
Adjust the density and color balance of a bright section. (Y/M/C/K color)
Adjustment method
- When you set a smaller value, fogging is reduced.
1
Adjustment range
-32 to +32
[Factory setting value / Value after RAM clear: 0]
LD-OFS-Y/M/C/K
Adjust the color balance of low-density area. (Y/M/C/K color)
2
Adjustment range
-8 to +8
[Factory setting value / Value after RAM clear: 0]
Use of this mode must be avoided as much as possible when the machine has been operating
normally.
MD-OFS-Y/M/C/K
Adjust the color balance of middle-density area. (Y/M/C/K color)
2
Adjustment range
-8 to +8
[Factory setting value / Value after RAM clear: 0]
Use of this mode must be avoided as much as possible when the machine has been operating
normally.
COPIER>ADJUST>PASCAL
Subheading Contents
Level