Canon imagePRESS C1 Service Manual - page 152
Manual is about: imagePRESS C1 Series
of
1265
Chapter 2
2-58
F-2-180
17) Run the control panel interface cable [1] through the arm cover 1 [2].
18) Attach the arm cover 1 [2] while hanging the claw [3] on the cut-off [4]
of the arm unit.
F-2-181
19) Fix the arm cover 1 from behind the arm unit.
- 2 screws (P tightening; M4X10) [1]
F-2-182
20) Fit the shaft [1] of the control panel into the arm unit [2].
F-2-183
21) Tighten the flat screw [1] from behind the upper arm.
Be careful not to catch the cable.
Check to be sure that there is no displacement between the arm cover 1 and
the arm cover 2.
[2]
[1]
[3]
[1]
[4]
[3]
[2]
[1]
Be sure to fit the tip of the control panel shaft [1] into the round hole of the
upper arm.
[1]
[2]
[1]
[1]