Canon imagePRESS C1 Service Manual - page 145
Manual is about: imagePRESS C1 Series
of
1265
Chapter 2
2-51
F-2-134
4) Put back the fixing/feeding unit [1].
F-2-135
5) Tighten the 5 screws [1].
F-2-136
6) Fit the drum fixing member [1].
- 1 screw [2]
F-2-137
7) Tighten the 2 process joint shafts [1] and the ITB joint shaft [2].
F-2-138
8) Connect the connector [1] and other 7 connectors [2].
F-2-139
9) Connect the 6 connectors [1], and fix it in place with the cable guide [2]
and the wire saddle [3].
F-2-140
Keep in mind not to mix up the harness.
[1]
[1]
[1]
- Hold the drum fixing member [3] steady when tightening the shaft of the
ITB joint shaft [2].
- If the drum fixing member is not held steady, the shaft [2] will rotate
without tightening.
[1]
[2]
[1]
[3]
[2]
[1]
[2]
[1]
[2]
[3]
[1]