Canon imagePRESS C1 Service Manual - page 448
Chapter 7
7-99
F-7-196
13) Detach the developing clutch cover [1].
- 5 screws [2]
F-7-197
14) Remove the developing clutch [1].
- 1 bearing [2]
- 2 E-rings [3]
F-7-198
7.14.23 ITB Cleaning Unit
7.14.23.1 Preparation for Removing the ITB Cleaning Unit
0013-9711
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front door.
2) Detach the process unit cover.
3) Lift the hopper unit.
4) Remove the primary charging assembly. (page 7-86)Reference [Re-
moving the Primary Corona Assembly]
5) Remove the pre-transfer charging assembly. (page 7-88)Reference [Re-
moving the pre-transfer corona assembly]
6) Remove the drum unit. (page 7-89)Reference [Removing the Drum
Unit]
7) Pull out the fixing/feeding unit.
8) Remove the intermediate transfer unit. (page 7-100)Reference [Remov-
ing the Intermediate Transfer Unit]
7.14.23.2 Removing the ITB Cleaning Unit
0013-9712
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the mounts (the front and the rear) [1].
- 4 screws [2]
F-7-199
2) Move the ITB cleaning unit [1] in the direction of [A], and then, move it
in the direction of [B] to remove.
F-7-200
Points to Note When Removing/Mounting ITB Cleaning Unit
In the case of removing/mounting the ITB cleaning unit, make sure not to
scratch the ITB [1] with the metal areas [2].
F-7-201
Points to Note When Mounting the ITB Cleaning Unit
In the case of attaching the mounts, make sure to attach the correct ones be-
cause the shape of the plates is different between the front one and the rear
one.
[1]
[1]
[1]
[2]
[3]
[2]
[1]
[2]
[1]
[2]
[3]
[2]
[2]
[1]
[1]
REAR
FRONT
[B]
[A]
[1]
[1]
[2]
[2]