Canon imagePRESS C1 Service Manual - page 136
Chapter 2
2-42
F-2-89
F-2-90
3) Open the 2 developing assembly fixing arms [1].
- 2 screws [2]
F-2-91
4) Remove the protective sheet [1] attached at the toner supply mouth of the
developing rotary.
F-2-92
5) Hold the developing assembly so that the developing cylinder is facing up-
ward, remove the desiccating agent [1] and the protective member [2].
F-2-93
6) Manually turning the developing cylinder gear [1] 5 to 6 times in the di-
rection of the arrow, to check if there is any scar on its surface and also
make the starter in the unit even out.
F-2-94
7) Remove the 2 tapes [1] to remove the sponges[2].
In the case of turning the developing rotary, make sure that the developing
assembly must be fixed with the screw.
[1]
[2]
[A]
[B]
[2]
[1]
[2]
[1]
Keep in mind not to touch the developing cylinder.
After the above operation, change the direction of the developing assembly
so that the taped-sponge comes upward.
Make sure to remove the sponges [2].
[1]
[1]
[2]
[1]
[2]