Canon imagePRESS C1 Service Manual - page 1065
Chapter 16
16-168
SPECK-SW
Use it to switch between the timing of white plate dust detection.
2
This is used at the occurrence of image line due to floating dust.
Settings
0: normal timing (default) ; 1: for each job
When setting the value as '1', first copy time (FCOT) gets longer.
SVMD-ENT
Switch the method of entering the service mode.
2
Setting range
0: Press the [User Mode] key. --> Press [2] and [8] at the same time. --> Press the [User Mode]
key.
1: Press the [User Mode: key. --> Press [4] and [9] at the same time. --> Press the [User Mode]
key.
Standard value
0
W-CLN-PH
Set the interval of automatic cleaning of the primary charging wire and pre-transfer charging wire.
This mode is used to change the interval of automatic cleaning of the primary charging wire and
pre-transfer charging wire when a poor image (vertical line, etc.) occurs in the high temperature/
humidity environment.
Use "W-CLN-P" mode to set the interval of automatic cleaning of the primary charging wire in
normal environment.
2
Setting range
100 to 10000 (can be set in the unit of 1)
Standard value
1000
SSH-SW
Set whether or not to activate the SSH server.
Make this setting to specify whether or not to activate the SSH server when activating the main
unit.
2
Setting range
0: Do not activate the SSH server when activating the main unit.
1: Activate the SSH server when activating the main unit.
Standard value
0
SSH server does not start by changing the setting value to 1(ON) while activating the main unit.
The setting value becomes available after turning the power switch OFF/ON.
Reference
SSH is the abbreviation of 'Secure Shell'. The communication between digital accessory (DA) and
iR device is encrypted to avoid being read from the outside.
RMT-LGIN
Set whether or not to permit remote login to the SSH server.
Make this setting to specify whether or not to permit remote login from the remote host (SSH
client: digital accessory) to the SSH server debug console.
2
Setting range
0: Do not permit remote login to the SSH server.
1: Permit remote login to the SSH server.
Standard value
0
This item becomes available only when the setting value of
COPIER>OPTION>BODY
Subheading Contents
Level