Canon imagePRESS C1 Service Manual - page 433
Chapter 7
7-84
F-7-109
8) Hold down the claw [1] and then slide the fixing feeding unit.
F-7-110
9) Slide the processing unit [1].
F-7-111
10) Place the A3 paper [1] onto the drum as shown in the figure.
This is for the purpose of light shielding.
F-7-112
7.14.1.3 Sliding the Processing Unit
0020-5127
imagePRESS C1+ (Printer) / imagePRESS C1+
1) Remove the drum fixing mount [1].
- 1 screw [2]
F-7-113
Points to Note When Attaching the Drum Fixtures
When attaching the drum fixtures, be sure not to rotate the drum clockwise.
If the drum is rotated clockwise, which is the reverse of its normal direction,
the scoop-up sheet may become soiled and toner may scatter.
2) Disconnect the 6 connectors [1], and remove the cable from the cable
guide [2] and the clamp [3].
F-7-114
3) Disconnect the 1 connector [1] and the 7 connectors [2].
[1]
[1]
[1]
[1]
A3
[1]
[1]
[2]
[1]
[2]
[3]
[1]