Canon imagePRESS C1 Service Manual - page 151
Chapter 2
2-57
F-2-173
10) Attach the upper right cover [1], which has been detached at step 2).
- 3 screws [2]
- 3 cover rubber pieces (Large) [3]
F-2-174
11) Attach the reader right cover, which has been detached at step 1).
- 3 screws [2]
- 3 cover rubber pieces (Large) [3]
F-2-175
12) Attach the arm cover 3 [1] on the lower side of the control panel arm unit
using the 2 screws (Binding; M4X10) [2].
F-2-176
13) Fit the claw [1] of the arm unit into the hole of the control panel arm unit
[2].
F-2-177
14) Turn the arm unit in the direction of the arrow to the position where the
screw hole [1] of the arm unit is aligned with the hole of the control panel
arm unit.
F-2-178
15) Fix the arm unit [1] using the screws (binding; M4X14) in the order of
the 1 [2] and the 4 [3].
F-2-179
16) Fix the control panel interface cable [1] using the 3 wire saddles [2].
[1]
[2]
[2]
[3]
[3]
[1]
[2]
[3]
[2]
[3]
[2]
[3]
[1]
[3]
[3]
[3]
[2]
[2]
[2]
[1]
[2]
- Be sure to tighten the screws in the order indicated.
- To prevent the control panel from hitting the Original delivery tray, get the
arm unit towards the direction of the arrow and tighten the screw.
Be sure to align the rear wire saddle with the Film [3].
[1]
[2]
[1]
[2]
[3]
[3]
[1]