Canon imagePRESS C1 Service Manual - page 398
Chapter 7
7-49
7.7 Developing Unit
7.7.1 Developing Unit Configuration
0012-7123
imagePRESS C1 P / imagePRESS C1
This machine has four developing assemblies (Y, M, C, Bk), which are stored in the developing rotary.
Each developing assembly has the same configuration. The toner bottles supply toner with different components (pigments).
The configuration and function of the developing assembly are shown below.
T-7-13
F-7-63
7.7.2 Developing Unit Configuration
0020-4168
imagePRESS C1+ (Printer) / imagePRESS C1+
This machine has 5 developing assemblies (L, Y, M, C, Bk), which are stored in the developing rotary.
Each developing assembly has the same configuration. The toner bottles supply toner with different components (pigments).
The configuration and function of the developing assembly are shown below.
T-7-14
F-7-64
7.7.3 Developing Assembly Drive Control
0012-7125
imagePRESS C1 P / imagePRESS C1
The developing assembly consists of the developing cylinder, developing stirring screw A, and developing stirring screw B, applying driving load.
When the developing motor (M3) and developing clutch (CL1) are turned on, driving load is communicated.
Configuration
Function
[1] Developing cylinder
Stores the developer (toner/carrier).
[2] Blade
Forms an even developer layer on the developing cylinder.
[3] Developer stirring screw
Stirs the developer and supplies it to the developing cylinder.
Configuration
Function
[1] Developing cylinder
Stores the developer (toner/carrier).
[2] Blade
Forms an even developer layer on the developing cylinder.
[3] Developer stirring screw
Stirs the developer and supplies it to the developing cylinder.
[1]
[2]
[3]
[1]
[2]
[3]