Canon imagePRESS C1 Service Manual - page 551
Chapter 9
9-14
9.3.1.2 Power Save Mode
0012-8134
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+
In the case of power save mode (power save mode/low power save mode/sleep mode), target temperature is set low at standby, and power saving is enabled by the
following controls:
- Stop the drive system
- Reduce the power distribution to the heater
9.3.2 Detecting the Passage of Paper
9.3.2.1 Detection for Paper Wrapping
0013-3429
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+
Inside delivery sensor (PS15) detects the paper wrapping over the fixing roller/belt. In the case of detecting the delay of paper lead edge by inside delivery sensor,
it is perceived as wrapping jam of the fixing to stop the fixing motor, and separate the fixing belt from the fixing roller. When the jam is cleared after the fixing
wrapping jam, it executes the detection of residual paper at the fixing inlet sensor (PS14).
F-9-14
PS14: Fixing inlet sensor
PS15: Inside delivery sensor
Mode
Target Temperature
Heater State
Fixing
Roller
External Heat
Roller
Fixing Belt
Fixing Main
Heater (H1)
Fixing Sub
Heater (H2)
External Heat
Roller Heater
(H3)
Inlet Roller
Heater (H4)
Standby Mode
165 deg C
200 deg C
95 deg C
OFF
ON
Alternately lighting of H3 and H4
Save Energy
Mode
Set to -10%
160 deg C
190 deg C
-
ON
OFF
ON
OFF
Set to -25%
140 deg C
160 deg C
-
ON
OFF
ON
OFF
Set to -50%
100 deg C
-
-
ON
OFF
OFF
OFF
Low Electricity Mode
100 deg C
-
-
ON
OFF
OFF
OFF
Sleep Mode
-
-
-
OFF
OFF
OFF
OFF
PS15
PS14