Canon imagePRESS C1 Service Manual - page 969
Chapter 16
16-72
F-16-24
T-16-72
COPIER>ADJUST>ADJ-XY
Subheading
Contents
Level
ADJ-Y-DF
Adjust the main scanning position for DF stream reading.
Adjustment method
- When you increase the setting value by 1, the starting position to read the image moves to the
front by 0.1mm.
- When you executed 'RAM clear' for the reader controller PCB or replaced the reader controller
PCB, enter the value indicated in the service label.
1
1 to 211
[Factory setting value: Factory adjustment value / Value after RAM clear: 109]
When you changed the setting value for this item, write down the changed value in the service
label.
ADJ-Y-FX
Adjust the main scanning position for DF fixed reading.
Adjustment method
- When you increase the setting value by 1, the starting position to read the image moves to the
front by 0.1mm.
- When you executed 'RAM clear' for the reader controller PCB or replaced the reader controller
PCB, enter the value indicated in the service label.
1
1 to 211
[Factory setting value: Factory adjustment value / Value after RAM clear: 103]
When you changed the setting value for this item, write down the changed value in the service
label.
Original
Read start position
Decrease the setting
(so that the read start
position moves toward the rear).
Increase the setting
(so that the read
start position moves
toward the front).