Canon imagePRESS C1 Service Manual - page 1042
Chapter 16
16-145
16.5.1.3 COPIER List
0020-6602
imagePRESS C1+ (Printer) / imagePRESS C1+
1. INSTALL
T-16-146
HD-CHECK
Execute the partition check and recovery specified by CHK-TYPE.
Operation method
1) Select this item.
2) Press the OK key.
3) The result (1: OK, 2: NG (hardware), 3: NG (software), recovered sector / substitute sector) is
displayed.
1
HD-CLEAR
Initialize the partition specified by CHK-TYPE.
- When 0 or 4 is specified, this mode is invalid.
- When 1 is specified, the image control data saved in the SRAM area or versatile file saving area
is also initialized.
Operation method
1) Select this item.
2) Press the OK key.
When 1 or 3 is selected in CHK-TYPE and
after the power is turned OFF/ON.
It takes approximately five minutes for initialization. During the initialization, the progress bar
advances slowly. Do not turn off the power during initialization.
1
DEBUG-1
Use it to set the type of log to store/timing of storage to the HDD.
settings
0 to 3 (default: 0)
- Do not use for servicing (For the analysis of the cause of trouble)
- Obey the instruction by the quality support section for usage.
2
DEBUG-2
Use it to print out logs stored on the HDD.
1) Select the item.
2) Press the OK key.
3) See that the log is printed. (about 2 sheets of A4)
- Do not use for servicing (For the analysis of the cause of trouble)
- Obey the instruction by the quality support section for usage.
2
COPIER > FUNCTION > INSTALL
Subheading Contents
Level
STIR-Y/M/C/K
Stir developer in the developing unit (Y/M/C/K).
Select an item to highlight it and press the OK key. The operation starts.
1
STIR-4
Stir four-color developer in order.
Operation method
Select an item to highlight it and press the OK key. The operation starts.
1
SPLY-H-Y/M/C/K
Perform initial supply from the toner container (Y/M/C/K) to the toner buffer.
Select an item to highlight it and press the OK key. The operation starts.
1
SPLY-H-4
Perform initial supply from the four-color toner cartridge to the toner buffer.
Operation method
Select an item to highlight it and press the OK key. The operation starts.
1
CARD
Make a setting for installation of the card reader.
1 to 2001 [Factory setting value / Value after RAM L: 0]
Enter the card number and press the OK key. (Numbers for the number of cards specified by
COPIER > OPTION > BODY > CARD-RNG in Level 2 starting from the entered number are
available.)
The card control information (a section ID and password) is initialized.
1
COPIER>FUNCTION>SYSTEM
Subheading Contents
Level