Canon imagePRESS C1 Service Manual - page 563
Chapter 9
9-26
F-9-26
[1] Web feed roller
[2] Web take-up roller
[3] Cleaning web
[4] Web length detecting arm 1
[5] Web length detecting arm 2
PS22: Web length detecting sensor
UN4: Fixing driver PCB
FX_WEB_SNS: Fixing web length detecting signal
3) After the indication of the warning message of the fixing web length, when copies/prints are made after, the count of fixing web counter starts to increase. When
the 3000th count (A4) is reached, the machine indicates an error mode (E0005-0000).
Service Mode:
COPIER > OPTION > USER > WEB-DISP
ON/OFF of the warning message of the fixing web length
0 : OFF (In this case, the warning message is displayed on the initial screen of the service mode)
1 : ON [Default]
COPIER > COUNTER > DRBL-1 > FX-WEB
Fixing web counter
In the case of changing the fixing web, set the value clear '0' for the following service counters.
- COPIER > COUNTER > DRBL-1 > FX-WEB
Error Code:
E005 (Fixing web: absent)
0000 After the fixing web length detecting sensor detects the absence of the web, when printing more than 3000 counts.
9.5.3 Detached/Attached Mechanism of the Cleaning Web (Web Roller)
0013-7725
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+
In the case of cleaning the fixing roller, the cleaning web is locked/unlocked to the collecting roller by the web roller. When the fixing roller is under suspension,
the web roller is unlocked from the collecting roller to avoid heat-caused deformation of the fixing roller. The web roller is locked/unlocked to the collecting roller
by communication of the drive of the web detached/attached motor (M33). The fixing web detached/attached HP sensor (PS11) detects the home position to control
the web roller locking/unlocking.
UN4
J3306
1 2 3
GND
+5R
FX_WEB_SNS
PS22
[1]
[2]
[3]
[4]
[5]