Canon imagePRESS C1 Service Manual - page 636
Chapter 10
10-34
F-10-142
10.5.18 Decurler Driver PCB
10.5.18.1 Removing the Decurler Driver PCB
0013-9776
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front cover [1] and remove the left lower cover [2].
- 5 screws [3]
F-10-143
2) Remove the decurler driver PCB [1].
- 7 connectors [2]
- 6 screws [3]
F-10-144
10.5.19 Side Driver PCB
10.5.19.1 Preparation for Removing the Side Driver PCB
0013-9397
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the right rear upper cover. (page 10-12)Reference [Removing
the Right Rear Upper Cover]
10.5.19.2 Removing the Side Driver PCB
0013-9398
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the right upper cover [1] and remove one screw [2].
F-10-145
2) Remove the connector blanking cover [1].
- 1 screw [2]
F-10-146
3) Remove one grounding terminal screw [1], and remove one reuse band
[2].
4) Remove the harness [4] from one wire clip [3], and remove one connector
[5].
F-10-147
5) Remove the sheet metal [1].
- 5 screws [2]
When removing the sheet metal [1], the primary suction fan air filter may
come down. The air filter convex area is turned up, so be careful at installa-
tion.
[1]
[2]
[2]
[2]
[2]
[3]
[3]
[3]
[3]
[4]
[3]
[1]
[2]
[1]
[3]
[3]
[3]
[3]
[3]
[3]
[2]
[2]
[2]
[2]
[1]
[2]
[1]
[2]
[1]
[2]
[3]
[4]
[5]