Canon imagePRESS C1 Service Manual - page 142
Chapter 2
2-48
F-2-115
6) Fit the drum fixing member [1].
- 1 screw [2]
F-2-116
7) Tighten the 2 process joint shafts [1] and the ITB joint shaft [2].
F-2-117
8) Connect the connector [1] and other 7 connectors [2].
F-2-118
9) Connect the 6 connectors [1], and fix it in place with the cable guide [2]
and the clamp [3].
F-2-119
10) Remove the A3 paper[1].
F-2-120
11) Shift down the lock lever [1] in the direction of the arrow to release.
F-2-121
12) Hold it tight with both hands, and move the hopper assembly [1] down
slowly in the direction of the arrow.
- Hold the drum fixing member [3] steady when tightening the shaft of the
ITB joint shaft [2].
- If the drum fixing member is not held steady, the shaft [2] will rotate
without tightening.
[1]
[1]
[2]
[2]
[3]
[1]
[1]
[2]
[1]
[2]
[3]
[1]
[1]
[1]