Canon imagePRESS C1 Service Manual - page 650
Chapter 11
11-5
F-11-1
2) Make the following selections: [MEAP Settings] button > [Use HTTP] button> [On] button > [OK] button .
F-11-2
3) Press Done button as many times as necessary until the Basic screen appears.
4) Turn off the device's main power; wait for 10 sec, and then turn the power back on.
MEMO:
When using SSL, set [Use SSL] ON.
(This setting is also applied to the SSL setting of RUI. Same is true in the case of setting SSL ON on the side of RUI.)
Setting [Use SSL] ON displays the message dialogue 'Changes effective after the main power switch is turned OFF and ON' . Press [OK].
- The setting [Use HTTP] is not actually enabled/disabled until you have turned off and then on the device's main power switch.
- You cannot make a connection through a proxy server. If a proxy server is in use, enter the IP address of the MEAP device in the Exceptions field for the browser.
Open Internet Options dialog of Internet Explorer and select Connections tab, LAN Settings button, Use a proxy server option, and Advanced button of Proxy server
group. Proxy Settings dialog will opens. The Exceptions field is in the dialog. As network settings vary among environments, consult the network administrator.
- If Cookie and JavaScript are not enabled in the Web browser, you will not be able to use SMS.
- To type text using the Web browser, use the characters compatible with the MEAP device's touch panel display. The MEAP device may not properly recognize some
characters.
- When [se SSL] is made available, it is necessary to set the key and the certificate necessary for the SSL communication. Set the key and the certificate by SSL with
[Certificate Settings] that exists in [System Settings] > [Network Settings] > [TCP/IP Settings] on the iR device.