Canon imagePRESS C1 Service Manual - page 933
Chapter 16
16-36
3.ANALOG
T-16-44
4.CST-STS
T-16-45
5.JAM
PCI1
Display the name of the board connected to PCII.
30 characters or less
"-" (hyphen) is displayed when the board is not connected.
- Voice board:
- Encryption board:
- GIGA Ethernet board:
1
USBH-SPD
Display the connection speed of the USB device.
Display the connection speed of the eight USB devices connected to the USB-Host chip.
- OFF
- LOW
- FLL
- HGH
2
COPIER > DISPLAY > ANALOG
Subheading
Contents
Level
TEMP
Use it to check the machine inside temperature (environment sensor; in deg C).
1
HUM
Use it to check the machine inside humidity (environment sensor; in %RH).
1
ABS-HUM
Use it to check moisture content (environment sensor; in g).
1
DR-TEMP
Temperature around the photosensitive drum
Display the drum surface temperature detected by the drum thermistor.
Unit: deg C
Setting range: 0 to 60 deg C
1
FIX-UC
Use it to check the surface temperature of the middle of the fixing upper roller (as detected by the
main thermistor; in deg C)
1
FIX-UE
Use it to check the surface temperature at the edge of the fixing upper roller (as detected by the
sub thermistor; in deg C)
1
FIX-LC
Use it to indicate the temperature of the center of the fixing lower roller. unit: deg C
1
FIX-LE
Use it to indicate the temperature of the edge of the fixing lower roller. unit: deg C
1
FIX-EXC
Use it to indicate the temperature of the center of the outside heating roller. unit: deg C
1
FIX-EXE
Use it to indicate the temperature of the edge of the outside heating roller unit: deg C
1
DR-TEMPL
Temperature of the drum thermopile
Display the drum surface temperature detected by the thermopile.
Unit: deg C
Setting range: 0 to 60 deg C
1
COPIER > DISPLAY > CST-STS
Subheading
Contents
Level
WIDTH-MF
Use it to check the width of paper in the manual feed tray (in mm).
2
COPIER > DISPLAY > ACC-STS
Subheading
Contents
Level