Canon imagePRESS C1 Service Manual - page 478
Chapter 8
8-13
c. In case of duplexing re-pickup
F-8-14
p1: Point of start of acceleration (=a point where the trail edge reaches a point 20 mm downstream from the fixing nip area)
p2: Point of stop of duplexing reversal
p3: Point of stop of side registration
p4: Point of stop of duplexing re-pickup
p5: Point of start of deceleration
8.2 Basic Sequence
8.2.1 Cassette Feeding
0012-8459
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+
A4, plain paper, 2-sheet, Cassette 2 feeding, and face-up delivery
F-8-15
*1: Stops at pre-registration position.
There are acceleration/deceleration in the shaded intervals in the figure.
8.2.2 Manual Feeding
0013-5548
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+
A4, plain paper, 2-sheet, and face-up delivery
Interval Paper
delivery
speed
[A]
Normal speed mode: 285 mm/sec
1/3 speed mode: 95 mm/sec (=processing speed)
[B]
Normal speed mode: 627 mm/sec
1/3 speed mode: 314 mm/sec
[C]
600 mm/sec
[D]
500 mm/sec
A
B
C
D
E
p5
p4
p3
p2
p1
Cassette 1 / 2 pickup motor
(M15)
Cassette 2 pickup sensor
(PS34)
Cassette 2 pickup solenoid
(SL5)
Vertical path 2 sensor
(PS54)
Vertical path 2 motor
(M13)
OHT light-emitting/receiving
sensor _ front/rear (PS5/6)
Registration drive motor
(M6)
STBY
LSTR
*
1
*
1
*
1
*
1