Canon imagePRESS C1 Service Manual - page 970
Chapter 16
16-73
2. CCD
T-16-73
ADJ-X-MG
Make a fine adjustment of sub scanning magnification for reader copyboard reading.
1
Adjustment method
- When you executed 'RAM clear' for the reader controller PCB or replaced the reader controller
PCB, enter the value indicated in the service label.
Adjustment range
-50 to +50
[Factory setting value: Factory adjustment value / Value after RAM clear: 0]
When you changed the setting value for this item, write down the changed value in the service
label.
COPIER>ADJUST>CCD
Subheading
Contents
Level
W-PLT-X/Y/Z
Enter the white level data for the white plate.
Adjustment method
- When you executed 'RAM clear' for the reader controller PCB or replaced the reader controller
PCB, enter the value indicated in the service label.
- When you replaced the copyboard glass, enter the numeric value indicated on the copyboard
glass.
1
Adjustment range: 1 to 9999
[Factory setting value: Factory adjustment value / Value after RAM clear: W-PLT-X=8271 : W-
PLT-Y=8735 : W-PLT-Z=9418]
When you changed the setting value for this item, write down the changed value in the service
label.
EC-B/G/R
Display the correction value (Blue/Green/Red) after EC coat correction was performed, and enter
a value.
1
Adjustment range: 10000 to 15000
Standard value: 10000
COPIER>ADJUST>ADJ-XY
Subheading
Contents
Level