Canon imagePRESS C1 Service Manual - page 1025
Chapter 16
16-128
T-16-131
11. MISC-P
T-16-132
COPIER>FUNCTION>MISC-R
Subheading Contents
Level
SCANLAMP
Perform lighting operation of the scanning lamp.
Operation method
1) Select this item.
2) Press the OK key. The scanning lamp lights up for three seconds.
1
COPIER>FUNCTION>MISC-P
Subheading Contents
Level
P-PRINT
Print out the service mode setting value.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
It takes approximately 15 seconds before printing starts.
1
P-PRINT
Print out the service mode standard value
Execute the print out of the service mode standard value.
Left/right margin adjustment value (COPIER > ADJUST > FEED-ADJ > BLK-SML2) for the
second side on small size is added as an output item.
When executing P-PRINT with a printer model, an item for second-side left/right margin
adjustment value on small size was missing. Thus, this item is added in this change.
1
This item applies to the upgraded device or later (DCON Ver11.03 or later, Cont Ver24.04 or
later).
KEY-HIST
Print out the control panel key input history.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
1
HIST-PRT
Print out the jam history and error history.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
1
TRS-DATA
Transfer the data received in memory to the box.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
1
USER-PRT
Print out the user mode list.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
It takes approximately three seconds before printing is performed.
1
LBL-PRNT
Print out the service label.
Operation method
1) Set the A4/LTR paper in Cassette 1.
2) Select this item.
3) Press the OK key to perform printing.
It takes approximately 15 seconds before printing is performed.
1
PRE-EXP
Check the lighting operation of the post-exposure lamp (LED).
Operation method
1) Press an item to highlight it.
2) Press the OK key. Each operation is performed for a few seconds and stops automatically.
3) Press the OK key to perform printing.
Reference
When a failure occurs to the photosensitive drum caused by the lighting operation of the post-
exposure lamp, rotate the drum.
1