Canon imagePRESS C1 Service Manual - page 180
Chapter 2
2-86
F-2-318
15) Attach the grounding wire [1] to be matched with the embossed mark [2].
- 1 screw (TP; M4X6) [3]
F-2-319
16) Attach the fan unit [1].
- 1 screw (TP; M4X6) [2]
- 1 connector [3]
F-2-320
17) Put the Rubber bush [2] into the each 2 reader retaining plates [1]
F-2-321
18) Attach the reader retaining plate [1] to the sub station top plate (left
edge).
- 2 screw (TP; M4X6) [2]
F-2-322
19) Place this equipment [1] onto the top board of the substation, then move
it to the direction of the arrow and align it to the reader fixing plate left
[2].
F-2-323
20) Remove the protective sheet and all the tapes which are affixed on the
equipment.
21) Attach the reader.
- 2 Stepped screws (RS tighten; 6.4X2.5) [1]
F-2-324
22) Put the 1 Rubber bush [3]into the each holes found at the reader retaining
plate F (front right) [1] and the reader retaining plate R (rear right) [2].
F-2-325
23) Attach the reader fixing plate F (front right) [2] and the reader fixing
plate R (rear right) [3] to the reader [1] with pushing them onto the direc-
[1]
[3]
[2]
[1]
[1]
[2]
[3]
[1]
[2]
[1]
[2]
[1]
[2]
[1]
[2]
[1]
[1]
[2]
[3]