Canon imagePRESS C1 Service Manual - page 165
Chapter 2
2-71
setting position of the slide guide [2].
F-2-232
Move the slide guide toward the rear = left margin decreases
Move the slide guide toward the front = left margin increases
4) Tighten the screw loosened at step 3), and fix the slide guide.
5) Check to be sure that the left margin of image printed from the manual
feed tray is L1 = 2.5 +/-1.5 mm.
F-2-233
[1] Feeding direction of paper
2.2.42 Adjusting Margin along Leading Edge of Image
0012-9077
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
Adjusting method of margin along leading edge of image from each pickup
slot is described below.
1) Select COPIER > ADJUST > FEED-ADJ > REGIST from the service
mode.
2) Adjust by changing the setting.
(Each 1 setting value change results in the movement of 0.1 mm. The
image shifts toward the leading edge by setting the value larger.)
3) To activate the setting value, follow the shutdown sequence and turn OFF/
ON the main power switch.
4) Make sure that the margin along leading edge of image of which paper
was fed from each cassette / deck is L2 = 3.0 +1.5/-1.0 mm.
F-2-234
[1] Feeding direction of paper
2.2.43 Cleaning the Charging Assembly
0014-3040
imagePRESS C1 P / imagePRESS C1
Perform the following procedure when image fault (vertical or horizontal
lines) occurs.
1) Open the front door
F-2-235
2) Remove the cover [1] of the process unit.
- 4 screws [2]
F-2-236
3) Pull the shutter lever [1]found at the hopper fully toward you
F-2-237
4) Open the toner replacement cover [1]
F-2-238
5) Remove the hopper cover (Right) [1].
- 1 screw [2]
[1]
[2]
image
L1
[1]
image
L2
[1]
[1]
[1]
[2]
[1]
[1]