Canon imagePRESS C1 Service Manual - page 558
Chapter 9
9-21
F-9-20
[A] Center
[B] Displaced in the rear
[C] Displaced in the front
[D] Further displaced in the rear from the position of [B]
[E] Further displaced in the front from the position of [B]
3) In the case of detecting the position of [B] or [C] indicated above, move the fixing belt to the center. Each bearing [2] for the steering roller shaft turns in the
opposite directions in the front and the rear by the drive of the fixing belt displacement control motor (M35), causing the skew of the steering roller shaft, and
the fixing belt is displaced the shaft direction.
F-9-21
4) In the case of detecting the position of [D] or [E], the machine stops the drive to detect as an error because the adjustment of the belt displacement is timed-out.
Error code:
E007 (Belt displacement error)
0001 : Front side belt displacement error
0002 : Rear side belt displacement error
0007 : Detection of displacement error by the double error detection
0010 : In the case that after the steering monitor ON, HP detection failed to be within 1 sec.
0100/0200 : HP detection error on initialization
PS59
PS62
PS59
PS62
PS59
PS62
PS59
PS62
PS59
PS62
[D]
[B]
[A]
[C]
[E]
[1]
[2]
[2]
M35