Canon imagePRESS C1 Service Manual - page 1175
Chapter 16
16-278
DK3-ASST
Switch the air heater control for the pickup deck with air-assist function. (Setting for PDO deck
Lite)
Switch the condition to turn on the air heater for air-assist function according to the media and
environment.
1
Setting range
0: Control the air heater based on the media and environment condition.
1: Turn on the air heater based on the environment condition only. (Not dependent on the media)
2: Turn on the air heater constantly. (Not dependent on the environment and media)
Standard value: 0
Remarks
When switching the media setting from non-coated paper to coated paper for the pickup deck with
air-assist function, wait-time occurs before the temperature of the air heater is controlled. (For
coated paper, pickup cannot be performed until the air heater is turned on and warm air blows.)
Furthermore, when the machine is used in the environment near the ON/OFF switching condition,
it is assumed that the ON/OFF switching of the air heater is frequently performed and it increases
the wait-time.
When you receive a claim from a user that the wait-time is too long, perform the following
measures;
- For the former case (switching from the non-coated paper to coat paper), explain that there is
some worry that the transformation of non-coat paper will deteriorate, switch to 1, even for the
non-coat paper, depending on the environment condition, the Air Heat can switch to On.
- The later case, (if the machine is used in the environment near ON/OFF switching), when the
temperature gets lower, explain that there is some worry that the transformation of non-coat paper
will deteriorate, switch to 2, regardless to media and environment, the Air Heat can always switch
to On.
Steps of Operation :
0. Check, depends on the media and environment, the Air Heater is switched to ON.
1. Check, only by the environment condition that the Air Heater is switched to ON.
2. Check, that the Air Heater is always switched to ON.
FX-BC-SW
Set ON/OFF of the wait-mode control for cooling of the fixing assembly.
1
Setting range: OFF [0] / ON [1]
Standard value: 0
CARD-DIR
4-pane postcard feeding direction setting
Set the feeding direction of 4-pane postcard.
1
Setting range: 0 to 1
0: Short edge feed only
1: Available to switch Long edge feed/Short edge feed.
Standard value: 0
This item applies to the upgraded device or later (DCON Ver11.03 or later, Cont Ver24.04 or
later)
SIZE-DET
Set ON/OFF of the document size detection function.
2
Setting range
0: OFF (This eliminates glare because the optical system does not light up when the copyboard is
opened/closed.)
1: ON
Standard value: 1
DATE-DSP
Switch the date display.
2
Setting range:
0: YYMM/DD
1: DD/MM'YY
2: MM/DD/YY
MB-CCV
Restrict the use of the control card for mailbox.
2
Setting range
0: Do not restrict the use.
1: Restrict the use.
Standard value: 0
TRY-STP
Set a mode not to perform printing when the tray is full.
2
Setting range
0: Normal mode (Stop printing when the finisher tray is full.)
1: Stop printing only by detecting the height.
Standard value: 0
MF-LG-ST
Set a key for the long length paper mode.
2
Setting range
0: Normal
1: Display the long length key in the corresponding mode screen.
Standard value: 0
CNT-DISP
Set whether or not to display a serial number when pressing the counter check key.
2
Setting range
0: Display a serial number.
1: Do not display a serial number.
Standard value: 0
COPIER > OPTION > USER
Subheading Contents
Level