Canon imagePRESS C1 Service Manual - page 580
Chapter 9
9-43
9.7.5.3 After Replacing the Fixing Belt
0014-4440
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
Before installing a belt, apply silicon oil (S-20; FY9-6011) to the marked
area of the pressure pad cover (within the radius of about 200 mm from the
center).
Apply silicon oil to the pressure pad cover, after soaking lint-free paper into
the oil to the extent that the oil does not drip from the paper.
F-9-81
[1] pressure pad cover
When replacing the fixing roller / the fixing belt, or both of them, be sure to
clean the surface of the fixing roller and the fixing belt with a lint-free paper
moistened with alcohol.
Cleaning the Fixing Roller
The fixing roller [2] rotates by turning the fixing motor [1] in the direction
shown by the arrow. Clean evenly across the fixing roller with a lint-free pa-
per moistened with alcohol while turning the fixing motor [1]. Clean for 1 to
2 rotations of the fixing roller [2].
F-9-82
Cleaning the Fixing Belt
The fixing belt [2] rotates by turning the belt [1] in the direction shown by
the arrow. Clean evenly across the fixing belt with a lint-free paper mois-
tened with alcohol while turning the belt [1]. Clean for 1 to 2 rotations of the
fixing belt [2].
F-9-83
Remedy for Fixing Belt Replacement
The fixing belt may be displaced while rotating. When attaching it, be sure
that the fixing belt is located at the center.
1) Turn the gear until it stops.
If turned in the direction shown by [A], the fixing belt shifts closer to [a]
when turning the belt.
If turned in the direction shown by [B], the fixing belt shifts closer to [b]
when turning the belt.
F-9-84
2) Turn the belt to shift the fixing belt to the center position.
Error code:
E007 (Belt displacement error)
0001 : Front side belt displacement error
0002 : Rear side belt displacement error
0007 : Detection of displacement error by the double error detection
0010 : In the case that after the steering monitor ON, HP detection failed
to be within 1 sec.
0100/0200 : HP detection error on initialization
[1]
[2]
[1]
[1]
[2]
[A]
[B]
[a]
[b]