Canon imagePRESS C1 Service Manual - page 626
Chapter 10
10-24
F-10-84
6) Remove the arm cover 4 [1] from the back of the arm unit.
- 1 screw [2]
F-10-85
7) Remove the control panel interface cable [1].
- 1 connector [2]
- 1 clamp [3]
- 2 wire clips [4]
F-10-86
When Fixing the Control Panel Interface Cable
Adjust the cable length so that the cable [1] is in the inside of the sheet metal
[2].
F-10-87
8) Remove the ferrite core [1].
F-10-88
9) Remove one screw [1] from the backside of the control panel.
F-10-89
10) Remove one flat screw [1] from the back of the upper arm.
F-10-90
11) Remove the control panel shaft [1] from the arm unit [2].
F-10-91
When fixing the control panel shaft
Fix the control panel shaft [1] edge into the upper arm circular hole.
[1]
[3]
[3]
[2]
[1]
[2]
[1]
[4]
[3]
[2]
[2]
[2]
[1]
[1]
[1]
[1]
[1]
[1]
[2]