Canon imagePRESS C1 Service Manual - page 873
Chapter 15
15-10
E531
There is an error in stapling (finisher/saddle finisher)
0001 The home position sensor does not go off within a specific period
of time after the stapler motor has started to rotate.
1) Check the wiring between the finisher controller PCB and the
stapler. Is the wiring normal?
2) Try replacing the stapler. Is the problem corrected?
0002 The home position sensor does not go on within a specific period
of time after the stapler motor has started to rotate.
1) Check the wiring between the finisher controller PCB and the
stapler. Is the wiring normal?
2) Try replacing the stapler. Is the problem corrected?
E532
There is an error in the shift mechanism of the stapler (finisher/saddle finisher).
8001 The home position sensor does not go off within a specific period
of time after the stapler shift motor has started to rotate.
1)Check the stapler shift home position sensor. Is the sensor
normal?
2)Check the wiring between the finisher controller PCB and the
stapler shift motor. Is the wiring normal?
3)Check the path of the stapler shift base. Is there a mechanical
obstacle?
4)Try replacing the stapler shift motor. Is the problem corrected?
8002 The home position sensor does not go on within a specific period
of time after the stapler shift motor has started to rotate.
1)Check the stapler shift home position sensor. Is the sensor
normal?
2)Check the wiring between the finisher controller PCB and the
stapler shift motor. Is the wiring normal?
3)Check the path of the stapler shift base. Is there a mechanical
obstacle?
4)Try replacing the stapler shift motor. Is the problem corrected?
E535
There is an error in the staple swing mechanism (finisher/saddle finisher).
8001 The home position sensor does not go off even when the swing
motor has rotated for a specific period of time.
1)Check the swing home position sensor. Is the sensor normal?
2)Check the wiring between the finisher controller PCB and the
swing motor. Is the wiring normal?
3)Check the swing mechanism. Is there a fault?
4)Try replacing the swing motor. Is the problem corrected?
8002 The home position sensor does not go on even when the swing
motor has rotated for a specific period of time.
1)Check the swing home position sensor. Is the sensor normal?
2)Check the wiring between the finisher controller PCB and the
swing motor. Is the wiring normal?
3)Check the swing mechanism. Is there a fault?
4)Try replacing the swing motor. Is the problem corrected?
E537
There is an error in rear alignment (finisher/saddle finisher).
8001 The home position sensor does not go off within a specific period
of time after the swing motor has started to rotate.
1) Check the post-aligning plate home position sensor. Is the
sensor normal?
2) Check the wiring between the finisher controller PCB and the
post-aligning plate motor. Is the wiring normal?
3) Check the path of the aligning plate. Is there a mechanical
obstacle?
4) Try replacing the post-aligning plate motor. Is the problem
corrected?
8002 The home position sensor does not go on within a specific period
of time after the swing motor has started to rotate.
1) Check the post-aligning plate home position sensor. Is the
sensor normal?
2) Check the wiring between the finisher controller PCB and the
post-aligning plate motor. Is the wiring normal?
3) Check the path of the aligning plate. Is there a mechanical
obstacle?
4) Try replacing the post-aligning plate motor. Is the problem
corrected?
Code
Cause (Detection Description)
Remedy