Canon imagePRESS C1 Service Manual - page 882
Chapter 15
15-19
15.2.2 E602 (HDD/Encryption board error) detail
0019-4907
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+
In case of XX=[00]
E842
Error in unlocking of external heat roller
0009 With the fixing roller in stop state, hardware has detected that the
external heat roller had remained in contact with the fixing roller
for 300 msec or more continuously.
Check the detached/attached motor of the external heat roller.
Check the HP sensor of the external heat roller.
Error in locking of external heat roller
0001 The HP sensor does not go on within 5 sec after the start of a HP
search.
Check the detached/attached motor of the external heat roller.
Check the HP sensor of the external heat roller.
0011 The HP sensor is logically displaced at the time of executing
operation.
Check the detached/attached motor of the external heat roller.
Check the HP sensor of the external heat roller.
0101 At the time of finishing the operation, it is not positioned in a
specified position.
Check the detached/attached motor of the external heat roller.
Check the HP sensor of the external heat roller.
1001 Between HoldOn at starting operation and MtrOn (50msec), the
theory of sensor has changed
Check the detached/attached motor of the external heat roller.
Check the HP sensor of the external heat roller.
Error in locking of fixing belt
0002 The belt HP sensor does not go on within 5 sec after the start of a
HP search.
Check the detached/attached motor of the fixing belt. Check the
HP sensor of the fixing belt. Check the attached sensor of the
fixing belt.
0012 The HP sensor is logically displaced at the time of executing
operation.
Check the detached/attached motor of the fixing belt. Check the
HP sensor of the fixing belt. Check the attached sensor of the
fixing belt.
0102 At the time of finishing the operation, it is not positioned in a
specified position.
Check the detached/attached motor of the fixing belt. Check the
HP sensor of the fixing belt. Check the attached sensor of the
fixing belt.
1002 Between HoldOn at starting operation and MtrOn (50msec), the
theory of sensor has changed
Check the detached/attached motor of the fixing belt. Check the
HP sensor of the fixing belt. Check the attached sensor of the
fixing belt.
Error in locking of web
0003 The web HP sensor does not go on within 5 sec after the start of a
HP search.
Check the detached/attached motor of the cleaning web.
0013 The HP sensor is logically displaced at the time of executing
operation.
Check the detached/attached motor of the cleaning web.
0103 At the time of finishing the operation, it is not positioned in a
specified position.
Check the detached/attached motor of the cleaning web.
1003 Between HoldOn at starting operation and MtrOn (50msec), the
theory of sensor has changed
Check the detached/attached motor of the cleaning web.
E905
Error in air assist fan of paper deck
0001 The swing of the air assist fan does not return after 5 sec (During
the swing operation with the fan rotating, positioning sensor
logically does not change for 5 sec or more).
Check the connector of the air assist fan. Replace the air assist fan.
E906
Error in heater of paper deck
0001
continuously (hard port monitoring)
Replace the heater of the paper deck. Replace the deck driver.
0002
ready. With the heater for air-assist (separation by air) is activated,
the temperature is not high enough for controlled temperature
despite the passage of the specified time (hard port monitoring)
Check the power supply of the paper deck. Check the supplying
path. Replace the heater of the paper deck. Replace the deck
driver.
Code
Cause (Detection Description)
Remedy