Canon imagePRESS C1 Service Manual - page 631
Chapter 10
10-29
F-10-113
10.5.10 HV1 PCB
10.5.10.1 Preparation for Removing the HV1 PCB Unit
0013-9329
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the right rear upper cover. (page 10-12)Reference [Removing
the Right Rear Upper Cover]
2) Remove the right rear lower cover. (page 10-12)Reference [Removing
the Right Rear Lower Cover]
3) Remove the rear upper cover. (page 10-14)Reference [Removing the
Rear Upper Cover]
4) Remove the rear lower cover. (page 10-14)Reference [Removing the
Rear Lower Cover]
10.5.10.2 Removing the HV1 PCB Unit
0013-9335
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove two clamps [1] and one wire clip [2].
F-10-114
2) Remove the cover [1].
F-10-115
3) Remove six connectors [1].
F-10-116
4) Remove the main body rear exhaust fan duct [1] and the sheet metal [3].
- 1 screw [2]
- 1 connector [4]
5) Remove the cable [5] from the edge saddle [6].
F-10-117
6) Pull out the HV1 PCB unit [1] in the direction of the arrow.
- 3 screws [2]
[2]
[2] [2] [2]
[4]
[1]
[2]
[3]
[1]
[1]
[2]
[1]
[1]
[1]
[1]
[1]
[2]
[2]
[3]
[4]
[5]
[6]