Canon imagePRESS C1 Service Manual - page 1016
Chapter 16
16-119
2. LASER
RGW-ADR
Specify a URL for a sales company's server used for E-RDS.
[Factory setting value / Value after RAM clear: https://a01.ugwdevice.net/ugw/agentif010]
1
INISET-4
Automatic initial setting mode for installation of the main unit
Simultaneously execute a series of operation required for initial installation of each color
developer.
Since there are many working items required for initial installation of a color developer, this mode
is provided to minimize a mistake by a serviceman or improve his/her work efficiency.
The settings executed by this mode are shown below.
- Electric potential control
- Primary transfer ATVC
- Development idling (adjustment of the charging volume of the developer)
- Correction of the optical volume of the patch detection sensor (adjustment of the optical volume
of the patch detection sensor)
- Transfer cleaning ACVC (determination of high pressure of the transfer cleaning upstream/
downstream brush)
- Optical ATR initial setting (initial setting of noncontact optical ATR)
- Initial setting of patch electric potential control (initial setting of patch electric potential)
- Initial setting of patch detection (initial setting of patch detection ATR)
1
Operation method
1) Select an item to highlight it and press the OK key.
- Start the operation.
- Execute countdown.
2) After the operation completes, OK is displayed.
Remark
Use at initial installation of the machine unit.
Set '0' at AINR-OFF: Turn ON the initial multiple rotation execute SW
INISET-K
Initial installation of the k-color developer
Simultaneously execute a series of operation required for initial installation of the k-color
developer.
Operation method
1) Select an item to highlight it and press the OK key.
- Start the operation.
- Execute countdown.
2) After the operation completes, OK is displayed.
1
INIT-Y/M/C
Read the initial value of the toner density signal (SGNL, REF) for Y/M/C color.
Select an item to highlight it and press the OK key. The operation starts.
2
INIT-3
Read the initial value of the toner density signal (SGNL, REF) for 3 colors (Y/M/C).
Select an item to highlight it and press the OK key. The operation starts.
2
CLV-SET
Make a setting for the color guarantee mode (Not function at this machine.)
2
CLV-SEND
Send color guarantee information. (Not function at this machine.)
2
COPIER>FUNCTION>INSTALL
Subheading Contents
Level