Canon imagePRESS C1 Service Manual - page 578
Chapter 9
9-41
- Make sure to wipe off the excessive grease because the grease adheres to
the both edge [1] of the fixing roller when mounting the greased bushes
to the fixing roller.
F-9-72
When replacing the fixing roller / the fixing belt, or both of them, be sure to
clean the surface of the fixing roller and the fixing belt with a lint-free paper
moistened with alcohol.
Cleaning the Fixing Roller
The fixing roller [2] rotates by turning the fixing motor [1] in the direction
shown by the arrow. Clean evenly across the fixing roller with a lint-free pa-
per moistened with alcohol while turning the fixing motor [1]. Clean for 1 to
2 rotations of the fixing roller [2].
F-9-73
Cleaning the Fixing Belt
The fixing belt [2] rotates by turning the belt [1] in the direction shown by
the arrow. Clean evenly across the fixing belt with a lint-free paper mois-
tened with alcohol while turning the belt [1]. Clean for 1 to 2 rotations of the
fixing belt [2].
F-9-74
Remedy for Fixing Belt Replacement
The fixing belt may be displaced while rotating. When attaching it, be sure
that the fixing belt is located at the center.
1) Turn the gear until it stops.
If turned in the direction shown by [A], the fixing belt shifts closer to [a]
when turning the belt.
If turned in the direction shown by [B], the fixing belt shifts closer to [b]
when turning the belt.
F-9-75
2) Turn the belt to shift the fixing belt to the center position.
Error code:
E007 (Belt displacement error)
0001 : Front side belt displacement error
0002 : Rear side belt displacement error
0007 : Detection of displacement error by the double error detection
0010 : In the case that after the steering monitor ON, HP detection failed
to be within 1 sec.
0100/0200 : HP detection error on initialization
[1]
[2]
[1]
[1]
[2]
[A]
[B]
[a]
[b]