Canon imagePRESS C1 Service Manual - page 140
Chapter 2
2-46
F-2-106
8) Place a piece of A3 paper on a flat surface. Then turn the developing as-
sembly upside down and shake off the residual toner in the toner mouth
onto the paper.
F-2-107
9) Fit the developing assembly [1] to the developing rotary. Check to make
sure that the pin [2] of the developing assembly is fitted in the hole [3]
located at the backside of the developing rotary.
F-2-108
10) Push the 2 developing assembly fixed arms [1] in the direction of [A],
set them in the direction of [B] and fix.
- 2 screws [2]
Keep in mind not to touch the developing cylinder [2].
In the case of attaching the developing assembly, make sure not to bump
into the ATR sensor shutter [1].
[1]
[2]
[2]
[1]
[2]
[1]
- After attaching the developing assembly, check to see if the hole [2] of the
ATR sensor shutter [1] is embossed.
- Push the plunger [3] of the ATR sensor shutter solenoid in the direction of
the arrow several times, and check to see if it moves back and forth.
[1]
[2]
[3]
[1]
[3]
[2]
[2]