Canon imagePRESS C1 Service Manual - page 625
Chapter 10
10-23
F-10-77
10.5.5 Control Panel
10.5.5.1 Removing the Control Panel
0013-9407
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Lean the control panel [1] in the direction of the arrow.
F-10-78
2) Remove two cover rubber [1] and two screws [2].
F-10-79
MEMO:
When the control panel tilts at installation, implement the following adjust-
ment.
1) Loosen four screws [1] on the backside of the control panel.
2) Adjust and keep the control panel [2] at the desirable position, and tighten
the loosened screw.
F-10-80
3) Remove the hinge slide cover [1] in the direction of the arrow.
F-10-81
4) Remove the lock hinge cover L [1].
- 1 screw [2]
- 2 boss [3]
F-10-82
MEMO:
If the arm unit [1] is made perpendicular to the control panel [2], the lock
hinge cover is easy to remove (Same at installation).
F-10-83
5) Remove the lock hinge cover R [1].
- 2 screws [2]
- 2 boss [3]
[3]
[1]
[2]
[1]
[2]
[1]
[1]
[2]
[1]
[1]
[3]
[2]
[1]
[2]